Gwenhael Goavec-Merou
bdcdea9a2f
cable: added altera usb blaster III variant
2025-08-27 18:26:17 +02:00
José Miguel Sánchez García
3723bf7571
Add cable support for ARM-USB-TINY-H based off ARM-USB-OCD-H
2025-06-10 21:54:54 +02:00
Gwenhael Goavec-Merou
7a509b56ee
Merge pull request #541 from bl0x/numato-neso-support
...
Add support for Numatolab Neso board.
2025-04-24 06:59:25 +02:00
Mike Goelzer
ff1e77debf
adds GCM board type and FT4232H interface B cable
2025-04-23 07:04:40 -06:00
Bastian Löher
bdeb74b61e
Add support for Numatolab Neso board. Programming SRAM over USB works, when board jumpers are set for JTAG programming mode. SPI flashing does not work properly (does not boot).
2025-04-21 21:17:54 +02:00
Emard
fa1d328b93
esp_usb_jtag: new cable
...
- copy dirtyjtag to esp_usb_jtag, it compiles
- copy protocol definiton, defines and private data/struct from openocd esp_usb_jtag.c
- ulx3s_esp board with esp32s3 cable
- esp_usb_jtag specify usb vid:pid in jtag.cpp
- hardcode usb interface and endpoints
- getting caps
- set chip id (not applicable for fpga)
- tms write done, untested
- cleanup and toggle clk
- 32bit counting
- setting divisor (todo read base freq)
- div range within 1-255
- base speed from descriptor
- fix doc typo with swapped tms/tdi some cleanup but it doesn't work.
2025-04-18 07:32:15 +02:00
Stéphane Potvin
e3f315a121
Add support for Numato Systems Mimas A7 board.
2024-06-22 08:03:14 -04:00
Gwenhael Goavec-Merou
53578876d5
added support for Gowin GWU2X USB (JTAG mode) ( #434 )
2024-05-20 21:10:29 +02:00
Giovanni Bruni
2754e99215
cable: add FTDI FT4232HP mapping
2023-10-20 07:55:53 +02:00
Gwenhael Goavec-Merou
e9b31425d6
cable: efinix jtag ft2232 variant
2023-10-03 06:48:47 +02:00
Alexey Starikovskiy
0fc8ba10a8
Add WCH CH347T(mode #3 ) JTAG cable
...
Signed-off-by: Gwenhael Goavec-Merou <gwenhael.goavec-merou@trabucayre.com>
2023-07-26 08:17:57 +02:00
Andrew Dennison
ec82dd6467
jlink: support J-Link BASE and J-Trace PRO
2023-05-29 11:57:47 +10:00
Balint Cristian
933ed793e8
Add libgpiod v2 api support
...
Signed-off-by: Balint Cristian <cristian.balint@gmail.com>
2023-04-19 23:27:09 +03:00
chenzhuoyu
cf04d64377
feat: option to use an extra GPIO as the status indicator
2023-04-11 00:36:16 +08:00
Gwenhael Goavec-Merou
fd97c244d9
remoteBitbang_client: adding new protocol (client side)
2023-03-02 13:47:11 +01:00
Gwenhael Goavec-Merou
7f1f9445d4
cable: bus_addr, device_addr: int -> uint8_t
2023-02-25 17:10:01 +01:00
Cedric de Wijs
0bdef7bab1
typo's, added git as dependency
2022-12-18 13:56:54 +01:00
Gwenhael Goavec-Merou
106cdecc14
Merge pull request #260 from jeanbie0/jetson-nano-gpio
...
Add cable jetson-nano-gpio
2022-10-22 15:07:00 +02:00
Gwenhael Goavec-Merou
9e5fcdbe0d
src/cable: rename bus/device to bus_addr/device_addr
2022-10-15 16:19:24 +02:00
Gwenhael Goavec-Merou
3e20dc7082
src/cable: rework cable list. move vid/pid from mpsse_bit_config to cable_t
2022-10-15 16:15:23 +02:00
J Biemar
5a7e73b586
Add cable jetson-nano-gpio
2022-10-14 11:15:02 +02:00
Gwenhael Goavec-Merou
93aa9f4dd3
cable: add lpc-link2 support
2022-08-29 21:03:30 +02:00
Diego Herranz
f115608cb1
Add Steppenprobe cable
...
https://github.com/diegoherranz/steppenprobe
Config taken from OpenOCD repo:
https://sourceforge.net/p/openocd/code/ci/master/tree/tcl/interface/ftdi/steppenprobe.cfg
2022-08-09 18:31:16 +02:00
Niklas Ekström
f69ce8a465
Only show libgpiod cable in list if enabled
2022-07-22 10:01:23 +02:00
Niklas Ekström
12955b8711
Initial commit of libgpiod JTAG driver
...
Not tested yet.
2022-07-18 18:09:34 +02:00
Gwenhael Goavec-Merou
1f842e4ebc
cable: add missing mpsse_bit_config index
2022-06-02 08:51:47 +02:00
Gwenhael Goavec-Merou
7bfce0fb2b
xvc_client: Xilinx Virtual Cable client PoC
2022-04-10 16:02:39 +02:00
Stephan Ruloff
b60f37b56d
Support for the Papilio One board
2022-03-25 21:44:05 +01:00
Gwenhael Goavec-Merou
18100ec0f3
cable: new SEGGER J-Link support (PoC)
2022-03-12 18:46:23 +01:00
Gwenhael Goavec-Merou
74eb812c6d
cable: digilent jtag-smt2-nc
2022-03-10 18:52:47 +01:00
Gwenhael Goavec-Merou
fb2aadadad
cable: adding Olimex ARM-USB-OCD-H
2022-01-20 19:37:50 +01:00
Patrick Urban
d09e5da0ba
colognechip integration: initial commit
...
This commit adds support for the Cologne Chip GateMate FPGA series. Both
Evaluation Board and Programmer Cable are supported. Configurations can be
loaded into the FPGA with both devices via JTAG or SPI. In addition to
reading/writing data from/to flashes directly via SPI, this can also be done
via the built-in JTAG-SPI-bypass. A direct wiring between programming hardware
and flash is no longer necessary in this case.
Signed-off-by: Patrick Urban <patrick.urban@web.de>
2021-12-10 12:12:32 +01:00
Gwenhael Goavec-Merou
f843dc2eb2
ch552_jtag: driver for ch552_jtag firmware (ft2232c clone)
2021-11-06 10:33:25 +01:00
Gwenhael Goavec-Merou
649554f3fd
efinix: add jtag support, introduce oe_pin in board configuration, add xyloni jtag interface
2021-10-23 08:44:23 +02:00
Florent Kermarrec
7d8c8b2dcb
Add Trion T120 BGA 576 Dev Kit support.
...
This Dev Kit uses a FT2232 chip, so also rename efinix_spi with efinix_spi_ft4232
and introduce efinix_spi_ft2232.
2021-10-15 09:20:36 +02:00
Gwenhael Goavec-Merou
8f95303daf
move to APACHE-2.0 license
2021-06-26 15:24:07 +02:00
Vegard Storheil Eriksen
7fc0703167
cable: Add support for Orbtrace.
2021-06-22 23:59:46 +02:00
Gwenhael Goavec-Merou
827767b99f
add proof of concept / draft for DFU protocol. Add orangeCrab in DFU mode
2021-06-20 10:26:05 +02:00
Gwenhael Goavec-Merou
53c5d35da6
add cmsis dap (hid) support
2021-06-19 17:30:23 +02:00
ultraembedded
dc003f6212
As per feedback, allow 232H devices to have upper bank pins configured on init.
2021-06-11 11:24:57 +01:00
ultraembedded
291f1b6d6f
Add support for Digilent Digital Discovery and Analog Discovery 2 (openFPGALoader -c digilent_ad)
2021-06-10 22:38:17 +01:00
Gwenhael Goavec-Merou
49ba5f265a
add support for usb-blasterII
2021-05-13 16:11:22 +02:00
Gwenhael Goavec-Merou
4e2b1aa73e
cable: add SecuringHardware Tigard programmer
2021-03-27 18:43:56 +01:00
Gwenhael Goavec-Merou
cd625d4c99
add efinix Xyloni support (spi mode only)
2021-01-21 07:11:10 +01:00
phdussud
a11ec92a25
Fix gcc 10.2 error messages.
2020-12-12 15:48:45 -08:00
Giuseppe Gebbia
edad461d88
add support for artix-7 200t and nexys video board
2020-10-15 16:07:55 +02:00
Gwenhael Goavec-Merou
c41911d039
introduce anlogic JTAG adapter (tested with sipeed lichee tang
2020-08-20 16:57:25 +02:00
Gwenhael Goavec-Merou
4a3d1b3009
introduce intel usb blaster cable and de0nano board
2020-08-19 15:15:13 +02:00
Gwenhael Goavec-Merou
27b0c8a664
introduce DirtyJTAG cable
2020-06-14 15:41:00 +02:00
Jean THOMAS
eeefe48284
Add support for ECPIX-5
2020-05-12 19:09:30 +02:00