distributed installations, where the immediate installation location
is different from the final installation location, but in the case
where it is not desirable to put the entire install hierarchy as a
subdirectory of DESTDIR.
sticky flag set, and the type of the label does not correspond
exactly to the type under the label (e.g., label defined on m1
but is on top of a contact).
views. Because the abstract view does not necessarily represent
actual connectivity, rely on the port indexes in the .ext file
to determine the number of ports and port order. Do not use
SpiceNodeName() to look up the node name, or unique ports that
are deemed shorted will go missing. Also: Modified the read-in
of .ext files so that use names may contain backslashes. Only
backslashes that end a line will be handled differently.
flag definition had been put in database.h instead of database.h.in,
and so was deleted on "make clean". Also, corrected a problem that
causes the cif output style to be lost when running DRC-CIF checks
if the first output style is the DRC style.
only at the time of running the command "load". But cells are generally
loaded only on an as-needed basis, so the dereferencing option must be
saved as a flag in the cell and honored whenever its subcells are expanded
or otherwise read at a later time.
limit of the Calma definition, and probably has not done so for ages.
Nobody informed me of this. The restriction has been lifted from
GDS input and output in Magic. It can be reinstated if necessary by
setting a flag in the cifoutput section of the techfile, but it is
likely that this will not be necessary unless there are other tools
that enforce the limit and will not read a GDS file that exceeds it.
the right argument type (float, not int). Otherwise all resistances
from extresist come out zero when doing "ext2spice extresist on"
and "ext2spice hierarchy on". Also changed the format of the resistance
in the SPICE output to type float, since values are in standard units of
ohms, and rounding to the nearest ohm seems excessively coarse-grained.
a long-standing error (introduced with the "extresist geometry"
option) that can cause nets not to be extracted (due to the first
record not having extraction data, which was itself a long-standing
error in the code but which was not fixed correctly); (2) handle
"device mosfet" type transistors (previously only handled the old
"fet" type extraction devices); and (3) correct for the res.ext
file having a different scalefactor relative to the .ext file. The
latter item was solved by forcing all input to scale like
ExtCurStyle->exts_unitsPerLambda, locally correcting all input as
needed. Note that extresist still needs to handle other extraction
devices (e.g., resistors and capacitors) but those will require
additional handling in the routines which analyze the current path
to determine how to break up wires into paths.
include (1) specification of sidewall or surface to use for
each type individually, rather than a single method for all
types, and (2) specification of a linear model R = Ax + B for
the ratio limit when diodes are attached to the wire, where x
is the diode surface area (unitless, as this is a ratio).
an existing cell. If the existing cell has labels but the labels
are defined as point labels (no rectangle defined using specific
layer-purpose pairs), then the LEF macro's port geometry will be
used for the labels. Because the GDS file can define label sizes
and fonts, which the LEF file cannot, but because the LEF file may
define multiple rectangles per port, the original point label is
given the first port rectangle from the LEF file, while the
remainder of the labels in the LEF file generate new non-rendered
labels in the cell.
which takes the existing generated CIF plane, finds all enclosed
areas that have an area less than <area>, and fills them in. This
satisfies a minimum hole area rule in a way that is not possible
with any of the existing CIF operators.
Tim Edwards
Alex Coffin