that no nets will be checked for antenna gate and diffusion area,
and no antenna properties will be output to the LEF file. This can
greatly speed up LEF output file generation for a large design.
Thank you to Tamas Hubai for the code patch.
nets to be avoided for running antenna gate and diffusion area
checks when doing "lef write", which is to check if the pin of
the net is flagged with use "power" or use "ground". This avoids
the need to use the (recently added) "lef nocheck" option (although
that still exists as an additional way to control which nets do and
do not get checked).
that aren't actually handled by the "lef write" command. The three
mentions are "LEFsource", "LEFuse", and "LEFshape", all of which
refer to names of pin properties, not macro properties. These
mentions were probably left over from early work.
calculation of the area to check for output and the clip box
does not reduce the size of any layer associated with the
fixed bounding box declared by the FIXED_BBOX property.
"gds datestamp" for LEF reads. When set to non-default, all cell
definitions created from LEF macros will be given the specified
timestamp, which allows the stamps of abstract views to match the
stamps of full views, preventing issues of updated timestamps
whenever a layout is switched between views.
The website documentation now points to these contents in a clone
of the repository on opencircuitdesign.com, so all future edits of
the command-line documentation will be made directly to the git
repository. Also: Changed the precision of box values printed in
microns from 2 to 3 digits after the decimal place, so that 5 nanometer
grids do not get values clipped in the output.
Tim Edwards