meaning of the MAG record in GDS files. Most available GDS
documentation is decidedly vague about what MAG means. Most
layout tools seem to interpret a MAG of 1 as corresponding to a
text height of 1um. However, there are a few tools that
interpret it as 1 centimicron, and there's no reason to assume
that any given interpretation is correct. "gds magscale" allows
the scale to be redefined.
attempt is made to write an abstract view to GDS. This behavior can
be overridded with the new command option "gds abstract [enable|disable]".
Also: Corrected extraction to allow split tiles to be set as the
reference tile for a node. Previously this was allowed only if the
tile was the first to be searched, but that can cause different tiles to
be marked as the reference depending on where the search starts,
resulting in different names for the same node in .ext files, which is
bad. Also: Modified the LEF annotation to avoid bad entries in the LEF
that would create layers in the layout where none exist.
Compression levels of the output can be controlled with the "gds
compress [<value>]" command, where <value> 0 (default) is uncompressed
output, 6 is "normal" gzip compression, and 9 is maximum compression.
yesterday's commit to allow the syntax "gds maskhints <types>", in
which mask hints can be restricted to a specific list of layers
rather than all layers which define mask hints in the cifoutput
rule.
behavior, in which all cells read from GDS are given a zero
timestamp, and the timestamp is set when the file is written to
disk, the default behavior now is to set the layout cell's timestamp
from the timestamp provided in the GDS (the creation date timestamp,
specifically). The same command "gds datestamp" implemented in the
previous commit for GDS writes now also applies to GDS reads: If
set to "no", then the timestamp value from the GDS file is
transferred to the layout view (default behavior); if set to "yes",
then the timestamp is set to zero (legacy behavior). If set to
a value, then the value is used as the timestamp.
The website documentation now points to these contents in a clone
of the repository on opencircuitdesign.com, so all future edits of
the command-line documentation will be made directly to the git
repository. Also: Changed the precision of box values printed in
microns from 2 to 3 digits after the decimal place, so that 5 nanometer
grids do not get values clipped in the output.
Tim Edwards