statements in the .ext file output to those that mark a port as
equivalent to the node name used elsewhere in the file. This
limits unnecessary output of "equiv" statements that can bog down
ext2spice and other commands that use the .ext file contents.
implements a method for handling ports in a subcircuit that have different
port names and indexes but are shorted together. "none" is the default
and backwards-compatible behavior that merges ports together, which will
often cause one of the ports to be optimized out of the netlist. "resistor"
will separate the port names with a 0-ohm ideal resistor. "voltage" will
separate the port names with a 0-volt voltage source. This should work
well for simulation and potentially for LVS, although its impact on LVS
has not been fully investigated.
for sticky labels making connections through the hierarchy. This
is only needed for some annoying layouts that put point-size labels
with no connecting geometry in cells, and causes magic to spent
excessive amounts of time searching through labels for any layout
that has lots of labels.
not restored until after all cells have been processed through
extraction. Otherwise, top-down connections can end up with
different generated names for the same node, resulting in a
disconnect in the netlist.
areas and writes ANTENNAGATEAREA and ANTENNADIFFAREA values.
(2) Determines "USE POWER" or "USE GROUND" from label names
matching Tcl variables $VDD and $GND, if the USE has not been
registered as a cell property (knowning the use allows magic
to avoid writing an ANTENNADIFFAREA for power rails, although
doing so should not be an issue).
checks. Added new command "antennacheck" and a routine that
adds feedback entries where violations are found. Extended the
syntax of the extraction section of the techfile to support the
antenna ratios and antenna calculation methods.
added a long time ago, since capacitors use a different method for
calculating width and length than either transistors or resistors,
so subcircuits need a special class designator or else the extraction
may calculate the wrong dimensions for device width by totalling the
perimeter between the device and terminal types, as it would for a
MOSFET.
Tim Edwards