implements a method for handling ports in a subcircuit that have different
port names and indexes but are shorted together. "none" is the default
and backwards-compatible behavior that merges ports together, which will
often cause one of the ports to be optimized out of the netlist. "resistor"
will separate the port names with a 0-ohm ideal resistor. "voltage" will
separate the port names with a 0-volt voltage source. This should work
well for simulation and potentially for LVS, although its impact on LVS
has not been fully investigated.
code from extflat from type unsigned long to type TileTypeBitMask.
This increases the number of types of each to 256 and tracks the
number of types, so it should be difficult to exceed this amount.
support asymmetric FETs and other devices like bipolars that have
three distinct terminals. This does not go as far as it should to
make the array independent of the number of declared terminals of
the device. However, it suffices to make, e.g., parameter "a2=area"
work for a bipolar device, and to generate the right drain and source
areas and perimeters for asymmetric (e.g., extended-drain) devices.
used with "ext2spice hierarchy on" because the device index is not
reset between calls to output cells in the hierarchy, leading to
a mismatch of the index for all cells after the first one output.
development had been halted since it was first created back in April.
Version 8.2 is now the official development version, with the first
development push to create a Cairo graphics interface.
Tim Edwards