for sticky labels making connections through the hierarchy. This
is only needed for some annoying layouts that put point-size labels
with no connecting geometry in cells, and causes magic to spent
excessive amounts of time searching through labels for any layout
that has lots of labels.
not restored until after all cells have been processed through
extraction. Otherwise, top-down connections can end up with
different generated names for the same node, resulting in a
disconnect in the netlist.
areas and writes ANTENNAGATEAREA and ANTENNADIFFAREA values.
(2) Determines "USE POWER" or "USE GROUND" from label names
matching Tcl variables $VDD and $GND, if the USE has not been
registered as a cell property (knowning the use allows magic
to avoid writing an ANTENNADIFFAREA for power rails, although
doing so should not be an issue).
checks. Added new command "antennacheck" and a routine that
adds feedback entries where violations are found. Extended the
syntax of the extraction section of the techfile to support the
antenna ratios and antenna calculation methods.
added a long time ago, since capacitors use a different method for
calculating width and length than either transistors or resistors,
so subcircuits need a special class designator or else the extraction
may calculate the wrong dimensions for device width by totalling the
perimeter between the device and terminal types, as it would for a
MOSFET.
Tim Edwards